Our new Dog101 Halter - was designed here and made by Dogtraining101. It is made with stronger webbing materials - industrial thread for strength not standard sewing thread (as is normally the case), and the collar clip locks.  It has an additional d ring for graduating the dog back to a flat collar. The nose component is padded the entire length of the snout piece to stop rubbing which also helps to keep it in place. It has sliding side rings to allow the nose loop to sit naturally for the dog on the jaw line rather than being fixed in position.  There is an adjuster behind the head to obtain the correct amount of space for pressure release and is behind the head so there is no pulling the head sideways with potential for injury.  It comes in multiple colors and sizes to ensure the correct fit.  Since we make them we can custom size as required.
Sizes 0 -> 2 have a 15mm width Collar 
Sizes 3 and up have a 25mm width Collar
Noses pieces are 10mm and Padded with Neoprene.
 
Each size has 3 different neck sizes so get the best fit - all 5cm increments.
 
This allows for a large variation in neck to nose ratios - refer to sizing for more info.